Bed Wetting Alarm Cleaning and Storage

How do I clean the Intelliflex sensor and cord?

  1. Wash the IntelliFlex sensor with black face up under tap water (hot or cold) to wash off urine for 5 seconds – DO NOT USE SOAP OR LIQUID DETERGENT.
  2. Rinse the IntelliFlex sensor cord under tap water (hot or cold) – DO NOT WASH THE PLUG (the end that goes into the alarm unit).
  3. Place the IntelliFlex sensor upside down and gently tap to remove water from the traces.
  4. Pat the sensor and cord dry with a towel or cloth – (Do NOT pull on the cord or sensor while drying. It could cause damage).

My Intelliflex sensor will not detect urine

  1. Over time, urine salts can build up on the sensor. To remove these, please follow the steps below.
  2. Disconnect IntelliFlex sensor from the alarm unit.
  3. Wash the IntelliFlex sensor with black face up under tap water (hot or cold) to wash off urine for 5 seconds.
  4. Rinse the IntelliFlex sensor cord under tap water (hot or cold) – DO NOT WASH THE PLUG (the end that goes into the alarm unit).
  5. Place the IntelliFlex sensor upside down and gently tap to remove water from the traces.
  6. Pat the sensor and cord dry with a towel or cloth – (Do NOT pull on the cord or sensor while drying. It could cause damage).
  7. Reinsert the IntelliFlex sensor into the alarm unit. The alarm unit will beep twice and lights will flash.
  8. Gently pinch the bottom of the IntelliFlex sensor so the black traces touch (fold on each other). The alarm unit will beep and lights will flash.
  9. Press the enable button and disconnect IntelliFlex sensor from the alarm unit.
  10. Your IntelliFlex sensor is ready to detect bedwetting accidents..

Where can I order more Chummie Flexitape or order an additional IntelliFlex sensor?

  1. Please visit the Chummie Store or contact us at (408) 239-4050 and we can help you place your order.

How do I clean the Chummie bed wetting alarm?

  1. If needed, wipe the dry Chummie bed wetting alarm with a pre-saturated alcohol wipes to disinfect it.

How do I store Chummie bed wetting alarm during the day?

For daytime storage, disconnect the sensor from the alarm unit. The alarm unit beeps once and enters standby (power save) mode.